Post and Pole Mounting Hardware & Brackets . ... Woodlink Steel 4x4 Post Bracket. Steel braclet for mounting Woodlink and other wood bird feeders to a 4 x 4 post. ... Just screw this handy Ground Screw into the ground, slip your post into it and attach with a few screws. Item #DYBHM 3" x 2" x 2.25" $8.97.
If feasible, drill all the way through the post and use nuts and bolts. Or, use lead or plastic achors in your drilled holes in the concrete. Or, use epoxy in the holes and clamp your bracket in place until the epoxy sets.
Concrete screws come in 3/16- and 1/4-inch diameter, in lengths up to 3-3/4 inches. Both hex-head and Phillips-head styles are available. They can be used in concrete, block, and brick.
Buehner Block - Concrete Pier Block with Metal Bracket - Use as a 4 in. x 4 in. timber support. Ideal for building raised decks, walkways and floors. Up to 1,900 PSI compression strength.
A third option for attaching a post to solid concrete or concrete block is side mounting, which works well on an elevated masonry base, such as steps or a raised concrete porch. A good rule of thumb when side mounting is to attach at least one-third of the post below the top level of the concrete.
I want to build a 10x20 wood carport. Basically a roof on 4x4 posts. I wasn't wanting to drill into the concrete. I was wanting to know if there is a way to attach the 4x4 posts to the concrete without drilling into the concrete driveway.
Models are available for attaching to existing hardened concrete, wet concrete, as well as wood. ... ABA 4x4 ZMAX Galvanized Adjustable Post Base is rated 4.5 out of 5 by 213. ... Rated 4 out of 5 by Paul from Post sat snug in the bracket and made anchoring to... Post sat snug in the bracket and made anchoring to the footing quick, simple and ...
I will be putting a 4x4 vinyl sleeve over the 4x4 treated post. I am aware of the bracket that you fasten to the concrete, then to the post. Using that method concerns me about how stable the top of the post will be.
Re: 4x4 To Concrete Slab How about using some 1/2" all-thread, drill the concrete and epoxing the all-thread in leaving it stick up about 9". Then attach the posts like you would newel posts on a set of stairs.
the type used to attach a post to cement, in my case the 4x4 slips through into the hole in the bracket into the existing 4x4 hole the cement, where the old post used to be and, then 18 to 24 inches into dirt below the cement.
How to Attach a Wood Post to Concrete By: Danny Lipford. Attaching a metal post bracket to a concrete slab. ... Use lag bolts or screws to attach the metal post bracket to the concrete. Insert the wood post in the post bracket, and …
In the center of the bottom will be a hole. This is for the anchor that attaches there and goes into the concrete. You need to select anchors that are at least 4 inches long. This will give sufficient depth to offer proper support to the posts on the cement patio. Step 2 - Drilling. For drilling to the cement, attach a concrete bit to the drill.
Since you are covering the post with vinyl, you could weld 3.5" square x 1/8" wall steel tube to a base plate and bolt the base plate to the concrete with really good anchors. The steel tube is the same dimension as the 4x4 posts. You might be able to get less expensive pipe and put spacers on it to fill out to the 3.5" square dimension.
Allows easy installation of 4x4 wood posts on existing concrete 4x4 Post Base Support Flange Pro Version Handrail Support (actual size 3.5"x3.5") by 4x4 Post Support